Operation Manual: Evolution Series
Troubleshooting
Before performing any procedure in this section, please
disconnect AC power from the unit.
Improper servicing or adjustment practice can cause
equipment failure or serious physical injury. This
equipment must be adjusted and serviced by qualified
electrical maintenance personnel who are familiar with
the construction and operation of the equipment and
the hazards involved. Take diligent care during
adjustment. All exposed points on the control circuit
boards are electrically hot with respect to earth ground.
HIGH VOLTAGE IS EXPOSED WHEN THE LOWER REAR
PANEL IS OPENED ON THE SYSTEM. Dangerous voltages
exist on the circuit boards when powered. Disconnect
AC power from the unit while troubleshooting. Be alert.
High voltage can cause serious or fatal injury.
The Evolution 6100 and TCS are supplied with proper
heaters and settings for the specified operating voltage
(see label for information). Do not attempt to convert
unit to another power supply without contacting the
factory first!
To Next Page
Loading...
