About This Manual
Operation Manual: Evolution Series
Purpose
This manual covers the installation, routine operation, maintenance and repair of
your Evolution Dissolution Test System. It has information regarding the
commands, menus, indicators and controls. Chapter 1 provides an overview of the
system. Chapter 2 covers unpacking, installation, and qualification of the system.
Chapter 3 has operation and programming information. Chapters 4 and 5 cover
maintenance and troubleshooting. Please read Chapters 1, 2 and 3 before
proceeding.
Audience
This manual is written for any person responsible for maintaining, operating or
troubleshooting the Distek Evolution Dissolution Test System.
Contents
This manual is divided into chapters. The pages of the manual are numbered
providing easy navigation to assist in finding information quickly.
The following list describes the material covered in each chapter:
Chapter 1 - Introduction Provides a general overview and
warnings about the instrument.
Chapter 2 - Installation Describes how to unpack and properly
install the unit.
Chapter 3 - Operation Describes the functionalities of the
system and how to run the unit.
Chapter 4 - Maintenance Explains the steps necessary to
maintain the unit.
Chapter 5 - Troubleshooting Provides a troubleshooting chart and
description of error messages to assist
the user if a problem arises.
Appendix A – Spare Parts and
Accessories
Provides a table of recommended and
optional spare parts.
Appendix B - Pre-Installation
Considerations: Electrical Power
Supply
Recommendation information
pertaining to electrical power supply.
Appendix C - CE Declaration of
Conformity
CE Declaration of Conformity
certificate.
Appendix D - Certificate of
Compliance
Certificate of Compliance
Appendix E - Sample Printouts from
Parallel Printer
Sample printouts for a parallel printer.
To Next Page
Loading...
