Notice
This document contains proprietary information. All rights are
reserved. No part of this document may be photocopied,
reproduced or translated without the prior written consent of
Distek, Inc.
Distek, Inc.
121 North Center Drive
North Brunswick, NJ 08902-4905
Tel. (732) 422-7585
Fax. (732) 422-7310
Website: http://www.distekinc.com
“Dow Corning” is a registered trademark of Dow Corning Corporation, USA.
CenterChek, HeightChek, RPMChek, ShaftChek and TempChek are trademarks of Distek,
Inc.
The Distek logo is a registered trademark of Distek, Inc.
All other company and product names are trademarks or registered trademarks of their
respective holders.
Document Revision History
Rev Date Notes
A June 2003 Initial Release
B December 2003 See Distek Change Notice 0405
C October 2004
Updated for Firmware Rev. 2.13. See Distek Change Notice
0456.
D June 2005
Updated Appendix A: Spare Parts & Accessories. See Distek
Change Notice 0508.
E September 2005
Removed Certificate of Compliance from Manual. Certificate
is a separate file on manual CD. See Change Notice 0516.
Page B-1: Step # 5.3 – change “0.3V” to “2.0 V” and “0.5 V”
to “3.0 V”
Page D-2 and D-3 – add note to bottom of page - “Asterisk (*)
in Temperature Profiles denotes out of USP specification”
F May 2007 See Distek Change Notice 0580. Updated for FW Rev. 2.15.
To Next Page
Loading...
