16
IP2159EN
• In the case of automations with left-hand opening, you must invert the
assembly of the articulated arm as shown in the figure.
4
4
4
4
6.a.2 Assembling the left-hand articulated arm
6.b.1 Fixing the arm DAB805PSAF
A
C
B
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
25 Nm
A
210
min 550
90°
+/-
DAB805TFL
Arm extension kit
DAB805TFS
DAB805TKJ
• Move the door manually to check it opens and closes
correctly, without any friction.
• With the door closed, fix the arm to the arm support
[A] on the automation.
• Fix the bracket [B] to the door wing, forming an angle
of 90°. If necessary, lengthen (using the arm lengthen-
ing kit) or shorten the arm [C].
a
b
21026 44
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
25Nm
A
A
NOTE: open the door slightly and tighten
the screw of the arm support seat [A] at
25Nm (as shown in the figure).
If a torque wrench is not available, use a
hexagon wrench of the type shown in the
figure, gripping it on the long side and
tightening very firmly.
To Next Page
Loading...
