1. GENERAL RECOMMENDATIONS
To be read before further use of the unit.
• This manual constitutes an integral part of the product and must be kept near to the appliance for easy
and quick consultation.
• The regulator must not be used with functions different to those described below. In particular, it cannot
be used as a safety device.
• Before proceeding, check the limits of application.
1.1 SAFETY PRECAUTIONS
• Check the power supply voltage is correct before connecting the device.
• Only expose the front panel of the device to atmospheric agents: front protection with IP65 rating with rear
gasket. Only use the regulator within its working limits.
• Warning: Disconnect any electric connections before performing any type of maintenance.
• The device must never be opened.
• In the case of malworking or fault, send the device back to "DIXELL s.r.l. (see address) with a precise
description of the problem.
• Consider the maximum current applicable to each relay (see Technical Data).
• Make sure that the probe cables, the regulator power supply cables and the load cables remain separate
and sufficiently distant from each other, without crossing each other or forming coils.
• Install the probes in a way that they are not accessible to any users.
• In the case of applications in particularly critical industrial environments, it may be useful to also use
network filters (our mod. FT- PW network filter), (our mod. FT- IL filter to be connected in parallel to the
inductive loads).
To Next Page
Loading...