16.1 HOW TO MODIFY THE INFORMATION PRESENT IN THE MAIN SCREEN
To set the time and date, press the SERVICE key.
Use the UP and DOWN keys to select the TIME/TIME PERIOD icon and press ENTER.
To modify a element, position the cursor on the same and use the UP and DOWN cursors and press SET:
• The element starts to flash.
• Increase or decrease the value using the UP and DOWN keys.
• Confirm the modification by pressing the SETkey again.
The cursor will automatically position itself on the next element, to modify it repeat the operation just
described. ONCE THE TIME AND DATE HAVE BEEN MODIFIED, RE-START THE IPRO.
Press the ESC key several times to go back to the main screen.
To set the values to be displayed on the keyboard, modify the parameters from DP1 to DP4 (see
Programming parameters paragraph).
16.2 UNIT SWITCH-ON IN CONDITIONING OR HEATING MODE
To switch the unit on, if the parameter SP6=0, press:
• for the cooling mode (if SP6=1 the heating mode starts)
• for the heating mode (if SP6=1 the conditioning mode starts)
The information that appears in the main screen is:
• to indicate that at least one of the compressors is working.
• to indicate that the evaporator pump and/or the condenser pump are working (the
condenser pumps are present in the case of WATER-WATER configuration).
To Next Page
Loading...