dIXEL IPC400D SERIES - Expansion Module Connection to the Programmable Unit

!
USER MANUAL – Release 1.2 of 01/01/2010 Page 58 of 191
Version: 02/03/2010
9.2 EXPANSION MODULE CONNECTION TO THE PROGRAMMABLE UNIT
Using the CANBus serial output it is possible to connect up to a maximum of 4 expansion modules.
Use the relevant DIP switch to determine an unmistakable address between the connected modules.
Only use the connection between the GND terminals if there are communication problems between the
modules.
Use the jumper supplied to short circuit the "Term" connector on the programmable unit and in the expansion
module furthest away, after the connections have been made.
Dip switch: expansion module serial address