16.7.2 Time/Time bands
We have already seen previously that this menu is used for the time and date set.
It is also possible to enable or disable the Energy Saving and/or automatic switch off of the time bands.
By pressing the key, pass to the screen for the configuration of the three time bands.
To modify the values, position the cursor on the element and press the SET key:
• The element starts to flash.
• Increase or decrease the value using the UP and DOWN keys.
• Confirm the modification by pressing the SET key again.
The cursor will automatically position itself on the next element, to modify it repeat the operation just
described.
By pressing the key again, pass to the screen for weekly programming of the time periods for the
Energy saving and for automatic switch-off.
To Next Page
Loading...