Pushing the key it’s possible to enter the Level 1 (Pr1) parameters without typing any password.
To enter the Level 2 (Pr2) or Level 3 (Pr3) parameters the relevant password must be typed in
1
st
level parameters – No password needed
2
nd
and 3
rd
level parameters – relevant password required
Use the UP and DOWN cursors to select the family of parameters and press ENTER.
To modify a parameter, position the cursor on the same and use the UP and DOWN cursors and press SET:
• The element starts to flash.
• Increase or decrease the value using the UP and DOWN keys.
• Confirm the modification by pressing the SET key again.
The cursor will automatically position itself on the next element, to modify it repeat the operation just
described.
Press the ESC key several times to go back to the main screen.
To Next Page
Loading...