dIXEL IPC400D SERIES - XEV20 D Driver Module Connection to the Programmable Unit

!
USER MANUAL – Release 1.2 of 01/01/2010 Page 62 of 191
Version: 02/03/2010
11.2 XEV20D DRIVER MODULE CONNECTION TO THE PROGRAMMABLE UNIT
Using the CANBus serial output it is possible to connect up to a maximum of 4 driver modules.
Use the relevant DIP switch to determine an unmistakable address between the connected modules.
Use the connection between the GND terminals only if there are communication problems between the
modules.
Use the jumper supplied to short circuit the "Term" connector on the programmable unit and in the driver
module furthest away, after the connections have been made.
DIP switch: Drive module serial address