EasyManua.ls Logo

dIXEL IPC400D SERIES - Page 12

dIXEL IPC400D SERIES
187 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
!
USER MANUAL – Release 1.2 of 01/01/2010 Page 12 of 191
Version: 02/03/2010
• Allows maintenance of the circuit
• Allows "partialised" working of the unit
Possibility of enabling/disabling the individual compressor
• Maintenance of the individual compressor
• Malfunction
Complete management of pump down function:
• With dedicated pressure switch
• Timed
• Via the low pressure switch
• Via the low pressure transducer
Circuit unloading function:
• From evaporator inlet high water temperature
• From condenser inlet high water temperature (unit with heat recovery) – Not Available
• From high condensing pressure
• From low evaporating pressure
Controlled loads maintenance signal function:
• Compressors
• Evaporator pumps
• Condenser pump
Circuit auxiliary relay function:
• Four completely configurable relay outputs, also released from normal working of the unit controlled,
managed by means of NTC or PTC temperature probes or with 4÷20mA – 0.5 Volt pressure transducer
Weekly working in energy saving mode:
• Up to three daily time bands (devices with RTC option)
• From digital input
Weekly working with automatic switch on and switch off:
• Up to three daily time bands (devices with RTC option)
Dynamic set-point function:
• Managed by NTC or 4÷20mA input
Changeover function:
• Automatic changeover between cooling and heating by NTC input
Remote OFF function:
• From configurable digital input
Remote heating cooling function:
• From digital input with configurable logic
Hot start function:
• Air/air unit
Defrost management:
• In temperature in pressure or with both (combined control)
• Forced defrost for start-up with low external air temperatures
• From digital input or timed
• Manual using the relevant key
Boiler function:
• With integration heaters
N° 2 outputs for the proportional control of the condensing fan speeds via external module (inverter
or single/three phase phase cut) with configurable signal:
• PWM
• 0÷10 Volt
• 4÷20 mA
N° 6 outputs for 0÷10V proportional or ON/OFF control
• To control the servomotors working in free cooling or heat recovery mode
• For driving an external relay
Complete alarms management
• With internal data logger alarms (up to 100 events)
Up to n° 2 programmable remote LCD terminals with customisable values display
• with NTC probe on board for room temperature display and temperature control (Not Available).
Supervision/tele-assistance/remote monitoring for complete control and supervision from local and
remote
• By means of network output with ModBus TCP / IP protocol (INTERNET / INTRANET)
• Directly by telephone line (MODEL WITH INTERNAL MODEM)
• Indirectly by means of GSM modem or XWEB serial modem (MODEL WITH RS232 OUTPUT
PREPARATION)

Table of Contents

Related product manuals