dji INSPIRE 3 - Page 11

DJI Inspire 3 User Manual
©
2023 DJI All Rights Reserved.
11
2 Press the power button a minimum of ve times to transform the aircraft to Landing mode,
and power on
.
At this time, the indicators of the power button light up sequentially.
• Make sure that the lens locking lever is in the unlocked position and that both red dots
on the lens mount are aligned before mounting the camera lens.
• DO NOT press the lens release button while mounting the camera lens.
• Always toggle the lens locking lever to cover the orange mark on the camera until the
lever is tight and secure after mounting the camera lens. Otherwise, lens vibration may
occur during ight.
• Pay attention to sand, dust, and water when disassembling the gimbal camera or
replacing the lens. Make sure to operate in a dust-free environment, as dust that enters
the gimbal camera lens mount or lens may cause scratches and aect use.
• Follow the instructions in this manual to properly mount the replacement supported
lenses and related accessories to avoid damage caused by improper operation.
• Clean the surface of the camera lens with a soft, dry, clean cloth. DO NOT use
substances containing alcohol, benzene, thinners, or other flammable substances to
clean or maintain the camera.
• Press, and then press and hold the power button to power on the aircraft.
3. Remove the protective covers of the lens and gimbal camera lens mount. Install the lens (sold
separately) to the gimbal camera and remove the gimbal connector cover.
5
×
2
1
3
1
1
3
4
2
2
2