Simga2N Traction Advanced Manual– V1.3 Page 78 (166) ©2021 DMC GmbH Herten Germany
M1.13-5 Low speed deceleration damping factor “LSDcDamp”
This setting is used to damp the accelerator demand at speeds below 50% and is only active in speed mode.
In this case the damping effect is related to the actual speed value. If speed is low the speed responsiveness is
softer than at high speed while deceleration thus when release the accelerator
• • If set to 1.0 (no damping), means no effect on accelerator when released.
• • If set greater than 1.0 (low speed damped), the accelerator is “damped” at speeds below 50%
according to the number. This can help to be more precise and assure a smooth and accurate driving
at low speeds while releasing the pedal. This setting is active for any partial release of the accelerator
pedal. For full release of accelerator pedal the neutral brake behaviour take over.
The behavior of this parameter is explained by the following figure.
”M1.13-5 LsDcDamp” effect (speed mode only)
This damping affects only the in speed mode.
To Next Page
Loading...
