Compliance
32
XR2400F Installation Guide
Digital Monitoring Products www.dmpnet.com 2500 N. Partnership Boulevard Springfield, MO 65803
32.8 Proprietary Protective Signaling Systems
The total number of panels assigned to one MPX or DNET receiving line of the DMP SCS-1 Receiver system
must not exceed 90. This may be increased to 180 by setting the SNRM option to NO in the SCS-1 Receiver
system. This allows any report from a XR2400F to be sent to the receiver within 90 seconds.
32.9 Remote Station Protective Signaling Systems
You must provide 60 hours of standby battery. Up to four 12 VDC, 6.5Ah batteries may be used. See section
Standby Battery Power Calculations. Two Radionics Model D127 Reversing Relay Modules provide two
reversing polarity telephone connections. See section Remote Station Reversing Relay Connection and the
D127 Installation Instruction sheet for wiring details. A DMP Model 893 or 893A is used to provide two line dialer
communication or Type 1 Multiplex communication.
CALIFORNIA STATE FIRE MARSHAL SPECIFICATIONS
33.1 Bell output definition
The Bell Output of the XR2400F panel must be programmed to operate steady on burglary alarms and pulsed,
temporal, or California School Code on fire alarms. See sections 8.4A and 8.4B of the Programming Guide (LT-
0196).
To Next Page
Loading...
Need help?
General
