31
ED100LE 02-2021DL4616-001
dormakaba ED100LE operator – Fine cover
Installation Instructions
Chapter 10
. Install hardware into track
.. Assemble track.
CAUTION
Assemble track hardware based
on RH or LH installation.
. Remove both end caps () and one fixing
piece () from track.
. Slide bumper stop (), bumper () and
slide shoe assembly () into track.
• Do not tighten bumper stop M screw ().
. Secure fixing piece to end of track with
M x screw (.).
• Use No. Phillips, do not over-tighten.
Fig. 10.4.1 RH track assembly
1 Track
3 Fixing piece
9 Slide shoe
12 Bumper
Fig. 10.4.2 LH track assembly
1 Track
3 Fixing piece
9 Slide shoe
12 Bumper
16 Bumper stop
17 M5 x 13 FHMS
cross recessed
1
9
12
3
3
12
2
16
17
3
3
129
12
2
16
17
16 Bumper stop
17 M5 x 13 FHMS
cross recessed
. Assemble slide shoe
Fig. 10.5.1 Slide shoe and pivot pin
8 Slide shoe
9 1/2" pivot pin
10 1" Pivot pin
11 Retaining ring
8
9
11
10
.. Assemble slide shoe.
. Insert pivot pin into slide shoe.
. Install spring clip into pivot pin slot.
To Next Page
Loading...
