Dormakaba ED100LE - Page 51

51
ED100LE 02-2021DL4616-001
dormakaba ED100LE operator – Fine cover
Installation Instructions
Chapter 18
Fig. 18.3.6 Pull arm screw kit HK2719-020
1 10-24 x 1 1/2" pan
head Philips
slotted barrel nut
DF2718-01Z
2 10-24 x 1 1/4" flat
head Philips screw
DF2717-01Z
Fig. 18.3.4 Drive arm with CPD lever installed at 15 degree angle
5 5
Fig. 18.3.5 Mounting holes for track
5 Track mounting
holes
.. Install drive arm with axle extension.
. Install the drive arm with axle extension
(Fig. ..) onto the  pinion at a
minimum angle of  degrees.
. Thread M x  mm SHCS (for  mm
axle extension) into  pinion and
tighten SHCS.
NOTICE
M8 SHCS tightening torque.
Use torque wrench (25 ft-lbs) to
tighten SHCS to 17 ft-lb [23 Nm].
.. Drill holes in door for track
fasteners.
NOTICE
Pull arm installation template.
Reference Chapter 16 for
installation template.
. Use pull arm template to locate two
track mounting holes on door.
. Drill two holes in door for track
mounting.
• Reference Fig. .. for pull arm screw
kit.
NOTICE
Check hole locations for level.
Check mounting hole locations for
level prior to drilling holes.
1
2