Dormakaba ES 250 PRO - Page 47

47
WN 059677 45532 - 11/2023
ES 250 PRO/ES 250 PRO FST
ES 400 PRO/ES 400 PRO FST
Mounting instructions
The size of the detection field depends on the mounting height and the settings of
the sensor (see sensor manual). According to EN16005, the test piece CA must be
detected anywhere in the sliding door’s passage area. The size of the detection
zone depends on the mounting height and the settings of the sensor (see sensor
manual). Set the sensors’ detection zone in such a way that the doors do not run
into the test object.
Large opening widths may require several sensors.
Fig.77
200mm
Fig.78
200mm
Note
Further information can be found on the sensor manufacturers’
websites.
• beasensors.com
• bircher.com