Dräger Oxylog 2000 plu - Electromagnetic Emissions; Electromagnetic Immunity

Technical Data
114
Instructions for Use Oxylog 2000 plus SW 1.n
Electromagnetic Emissions
Electromagnetic Emissions
The Oxylog 2000 plus is intended for use in the electromagnetic environment specified below.
The user of the Oxylog 2000 plus should make sure that it is used in such an environment.
Emissions Compliance
according to
Electromagnetic environment
RF emissions (CISPR 11) Group 1 The Oxylog 2000 plus uses RF energy only for its internal
function.
Therefore, its RF emissions are very low and are not likely
to cause any interference in nearby electronic equipment.
Class B The Oxylog 2000 plus is suitable for use in all establish-
ments including domestic establishments and those
directly connected to the public low-voltage power supply
network that supplies buildings used for domestic
purposes.
Harmonic emissions
(IEC 61000-3-2)
Class A
Voltage fluctuations / flicker
(IEC 61000-3-3)
Complies
Electromagnetic Immunity
Electromagnetic Immunity
This Oxylog 2000 plus is intended for use in the electromagnetic environment specified below.
The user of the Oxylog 2000 plus should make sure that it is used in such an environment.
Immunity against IEC 60601-1-2 test level Compliance
level (of the
Oxylog 2000
plus)
Electromagnetic environment
electrostatic
discharge, ESD
(IEC 61000-4-2)
contact discharge: 6 kV
air discharge: 8 kV
8 kV
15 kV
Floors should be wood, concrete
or ceramic tile. If floors are cove-
red with synthetic material, the
relative humidity should be at
least 30%.
electrical fast
transients / bursts
(IEC 61000-4-4)
– power supply lines: 2 kV
– longer input / output
lines: 1 kV
–2 kV
–N/A
– Mains power quality should
be that of a typical commer-
cial or hospital environment.
– No input/output lines.