Dräger Oxylog 2000 plu - Ventilation Controls and Parameters

Instructions for Use Oxylog 2000 plus SW 1.n 21
Operating Concept
Ventilation controls
A Keys for selecting the ventilation modes:
– VC-CMV / VC-AC
– VC-SIMV (optional PS)
– SpnCPAP (optional PS).
B Rotary knob.
C Ventilation parameter controls
– Inspiratory tidal volume VT
[mL],
– Ventilation respiratory rate RR [/min],
– Maximum inspiratory pressure Pmax [mbar],
– O
2 AirMix or 100% O2 FiO2.
Selecting the ventilation mode
z Press the appropriate ventilation mode key (A)
for approximately 3 seconds.
Or
1 Press the appropriate ventilation mode key (A).
2 Press the rotary knob (B) to confirm. The
selected ventilation mode will be activated.
3 The active ventilation mode is displayed in the
upper left corner of the display (C).
Refer to the section "Operation" on page 45 for
additional information on ventilation mode
setting.
004
NOTE
Different ventilation modes and their parameters
can be set in the display window via the rotary
knob (e.g. Ti, PEEP, ∆Psupp, Pinsp).
– To select the parameter: turn rotary knob.
– To activate the parameter: press rotary knob.
– To set the value: turn rotary knob.
– To confirm the value: press rotary knob.
Oxylog 2000 plus
A
B
C
005
Oxylog 2000 plus
A
B
C