Vigor2860 Series User’s Guide
610
-S o:g <obj>
It means to specify Service Type object and IP group.
o – indicates “object”.
g – indicates “group”
<obj> – indicates index number of object or index number of
group. Available settings range from 1-96. For example, “-S
0 1" means the first service type object profile.
-S u <protocol>
<source_port__value>
<destination_port_vale>
It means to configure advanced settings for Service Type,
such as protocol and port range.
u – it means “user defined”.
<protocol> – It means TCP(6),UDP(17), TCP/UDP(255).
<source_port__value> –
1 – Port OP, range is 0-3. 0:= =, 1:!=, 2:>, 3:<
3 – Port range of the Start Port Number, range is
1-65535.
5 – Port range of the End Port Number, range is
1-65535.
<destination_port_value>:
2 – Port OP, range is 0-3, 0:==, 1:!=, 2:>, 3:<
4 – Port range of the Start Port Number, range is
1-65535.
6 – Port range of the End Port Number, range is
1-65535.
-F
It means the Filter action you can specify.
0 –Pass Immediately,
1 – Block Immediately,
2 – Pass if no further match,
3 – Block if no further match.
-q
It means the classification for QoS.
1– Class 1,
2 – Class 2,
3 – Class 3,
4 – Other
-l
It means load balance policy.
Such function is used for “debug” only.
-E
It means to enable APP Enforcement.
-a<index>
It means to specify which APP Enforcement profile will be
applied.
<index> – Available settings range from 0 ~ 32. “0” means
no profile will be applied.
-u<index>
It means to specify which URL Content Filter profile will be
applied.
<index> – Available settings range from 0 ~ 8. “0” means no
profile will be applied.
-c
It means to set code page. Different number represents
To Next Page
Loading...
Need help?
General
