VigorPro5300 Series User’s Guide
192
Long Preamble This option is to define the length of the sync field in an
802.11 packet. Most modern wireless network uses short
preamble with 56 bit sync filed instead of long preamble
with 128 bit sync field. However, some original 11b
wireless network devices only support long preamble.
Check it to use Long Preamble if needed to
communicate with this kind of devices.
Packet-OVERDRIVE This feature can enhance the performance in data
transmission about 40%* more (by checking Tx Burst).
It is active only when both sides of Access Point and
Station (in wireless client) invoke this function at the
same time. That is, the wireless client must support this
feature and invoke the function, too.
Note: Vigor N61 wireless adapter supports this function.
Therefore, you can use and install it into your PC for
matching with Packet-OVERDRIVE (refer to the
following picture of Vigor N61 wireless utility window,
choose Enable for activating TxBurst).
3
3
.
.
1
1
4
4
.
.
3
3
S
S
e
e
c
c
u
u
r
r
i
i
t
t
y
y
This page allows you to set security with different modes for SSID 1, 2, 3 and 4 respectively.
After configuring the correct settings, please click OK to save and invoke it.
By clicking the Security Settings, a new web page will appear so that you could configure
the settings of WEP and WPA.
To Next Page
Loading...
