Draytek VigorPro 5300 - Page 46

VigorPro5300 Series User’s Guide
38
Dest Port Start Displays the IP address for the start of the destination port.
Dest Port End Displays the IP address for the end of the destination port.
Click Index 1 to access into the following page for configuring load-balance policy.
Enable Check this box to enable this policy.
Protocol Use the drop-down menu to choose a proper protocol for the WAN
interface.
Binding WAN
interface
Choose the WAN interface (WAN1 or WAN2) for binding.
Src IP Start Type the source IP start for the specified WAN interface.
Src IP End Type the source IP end for the specified WAN interface. If this
field is blank, it means that all the source IPs inside the LAN will
be passed through the WAN interface.
Dest IP Start Type the destination IP start for the specified WAN interface.
Dest IP End Type the destination IP end for the specified WAN interface. If this
field is blank, it means that all the destination IPs will be passed
through the WAN interface.
Dest Port Start Type the destination port start for the destination IP.
Dest Port End Type the destination port end for the destination IP. If this field is
blank, it means that all the destination ports will be passed through
the WAN interface.