Duplo DSF-2000 - Upper Door Section; Removing Procedure; Adjusting the Magnet Catcher; Greasing the Secondary Conveyance Roller

1-20 99T-M12M0-0107-0
7. UPPER DOOR SECTION
7-1. Removing Procedure
(1) Remove the left and right limiters, remove the E ring of the pillar at the frame B side, and remove the washer.
(2) Remove the plate from the frame F side, and pull the pillar to remove the upper door.
7-2. Adjusting the Magnet Catcher
Adjust the position at which the magnet catcher is fixed so that the magnet catcher is attracted by the stopper at the
position where the clearance between the switch cover and stay is 3 to 4 mm (0.12" to 0.16"), or where the tilted
surface of the upper door is parallel to the tilted surface of the frame. (frame F side and frame B side)
7-3. Greasing the Secondary Conveyance Roller
This roller is pre-greased. When the grease runs out, a whistle-like buzzer is sounded.
Parallel to tilted surface
of frame
Adjusting angle
Secondary
conveyance rollers
Limiter
Switch cover
Stay
3 to 4 mm
(0.12" to 0.16")
Upper door
M6 washer × 3
Pillar
Pillar
Fulcrum plate
E ring
Frame B
Frame F