10 | Channel setup menu 4
D-ISC 100 x xx2
131
10.4.3.1.8.2 Graphic
Channel #1…#4
● Settings can be adjusted here for the graphic displays (bar
graph/XY graph) for the respective module, if these are act-
ive.
Press the
key to change…
Automatic scaling:
[
Auto scale]
● If enabled (on, 1), the start and end values for the scaling are
automatically calculated based on the measured values to be
displayed
● If disabled (off, 0), the following three values are used:
Scale start value:
[
Scale start value]
● Start value for bar graphs or the Y-axis of XY graphs.
Scale end value:
[
Scale end value]
● End value for bar graphs or the Y-axis of XY graphs.
10.4.3.1.8.3 Information
This is where device information on the respective module can
be found.
10.4.3.2 Analogue output
For assembly, also refer to 4.3.4 Analogue output [}53], and for
the module description see 3.4 Expansion modules [}25]. Also
refer to 15.10 Examples: Assignment of the analogue output (cur-
rent output) [}173] et. seq.
Assign source measured value
[
Assign source measuring values]
● Assign source measured value: indicates (list) which source
measured values are assigned to the 4 individual channels.
● After accessing the relevant channel AOm.1…4, the assign-
ment can be removed or a selection and assignment can take
place from the current list.
Functions
[
Functions]
● Service functions: enables the device to be restarted. Settings
that have not been saved may be lost and are no longer con-
sidered when restarting the device.
● Simulation functions: allow a value (simulation value) to be
assigned and the use of the assigned value (simulation re-
quest, activate simulation) for each of the 4 channels.
Specific parameter
[
Specific parameters]
● Signal range: displays the parameter for the signal range to
which the 4 individual channels are assigned; enables the dis-
played parameter to be edited.
● Error information: displays the assigned error value (in mA)
that is issued in the event of an error, for each of the 4 indi-
vidual channels, and also allows this value to be edited.
Whether and when the error signal is to be issued is also
defined here.
To Next Page
Loading...
Need help?
General
