17
800.788.5572 DuraLabel.com
GettinG started
6.4 Energy Saving Settings
POWER SAVE MODE
If you do not use the machine for a while, it will enter power save mode to control
the power consumption of the device. To cancel or initiate power save mode, press
the Power Save button on the control panel. The Power Save button illuminates
while in Power Save Mode.
NOTE: By default, the time interval to enter power save mode is set to 30 minutes.
You can change the time interval by pressing the Setting button on the control
panel. Then select Sys Cong Menu > Power Save Time.
SLEEP MODE
Your machine transitions from power save mode to sleep mode after a set period
of time. In sleep mode the power consumption of the device is minimal. The Power
Save button blinks while in sleep mode.
NOTE:
◦ The machine will not enter sleep mode if an error occurs and the machine
requires attention.
◦ By default, the time interval to enter sleep mode is set to 10 minutes. You can
change the time interval by pressing the Setting button on the control panel.
Then select Sys Config Menu > Sleep Time.
◦ It will automatically switch from Sleep Mode to Power Save Mode. In a network
environment with a large number of packets flows, your computer may respond
by automatically switching from Sleep mode to Power Save Mode. After a
period of time has elapsed, the computer will automatically enter into Sleep
Mode.
RETURNING TO STANDBY MODE
To return the machine to standby mode from power save or sleep mode, press the
Power Save button on the control panel.
NOTE: When your machine receives a print job, it automatically returns to standby
mode.
To Next Page
Loading...
