42
DuraLabel.com 800.788.5572
Menu functions
ITEM SETTINGS EXPLANATION
IP VERSION IP v4
IP v4+v6
IP v6
Sets up the IP version.
Operates with IPv4 only (not valid with IPv6).
Operates with both IPv4 and IPv6.
Operates with IPv6 only (not valid with IPv4).
From this stage, if IPv6 only is set from UI, for
example Telnet, “IP v6” appears as the value of
IP Version on the operation panel. “IP v6” will
disappear from the value if “IP v4” or “IP v4+v6”
is selected.
Display Condition: TCP/IP should be enabled.
USB MENU
This menu controls the operation of the printer’s USB data interface.
ITEM SETTINGS EXPLANATION
SOFT RESET ENABLE / DISABLE Enables or disables the SOFT RESET command.
SERIAL NUMBER ENABLE / DISABLE Specifies whether to ENABLE or DISABLE a USB serial
number. The USB serial number is used to identify the
USB device connected to your PC.
OFFLINE RECEIVE ENABLE / DISABLE Enables or disables this function. When set to Enable,
the interface retains a receive possible state even when
switching to Offline. Interface sends the BUSY signal only
when the receive buffer is full or a service call occurs.
SPEED 12Mbps / 480Mbps Selects the interface speed.
NOTE: When you have changed any settings in the USB MENU, turn the printer OFF,
then ON again.
FX EMULATION
This menu controls settings effective when the printer is operating in FX emulation
mode.
ITEM SETTINGS EXPLANATION
CHARACTER PITCH 10 CPI; 12 CPI; 17
CPI; 20 CPI;
PROPORTIONAL
Specifies character pitch in this emulation.
TEXT HEIGHT SAME
DIFF
Sets the height of a character.
SAME: Regardless of CPI, same height.
DIFF: As CPI, character heights vary.
FIT TO LETTER DISABLE
ENABLE
Sets the printing mode that can fit print data,
equivalent to 11 inches (66 lines), in the
LETTER-size printable area.
NETWORK MENU (continued)
To Next Page
Loading...
