58
DuraLabel.com 800.788.5572
Maintenance
11. Maintenance
11.1 Replacing Consumable Items
Only use DuraLabel Catalyst consumables to ensure the best quality and
performance from your hardware. Non original products may adversely affect your
printer's performance and invalidate your warranty. If you have any questions about
replacement of Catalyst consumables, contact Graphic Products.
TONER CARTRIDGE REPLACEMENT
NOTE: When the LCD display indicates TONER LOW, or if print appears faded, rst
open the top cover and try tapping the cartridge a few times to evenly distribute
the toner powder. This will enable you to obtain the best “yield” from your toner
cartridge.
To avoid toner waste and possible toner sensor errors, do not
change the toner cartridge(s) until “TONER EMPTY” is displayed.
The toner used in this printer is a very fine dry powder. It is contained in four
cartridges: one each for cyan, magenta, yellow and black.
Toner powder can stain surfaces. Have a sheet of paper handy so that you have
somewhere to place the used cartridge while you install the new one.
Dispose of the old cartridge responsibly, inside the pack that the new one came in.
Follow any regulations, recommendations, etc., which may be in force concerning
waste recycling.
If you do spill any toner powder, lightly brush it off. If possible, vacuum it or use a
cool, damp cloth to remove any residue.
Do not use hot water, and never use solvents of any kind. They will make stains
permanent.
If you inhale any toner or get it in your eyes, drink a little water or
bathe your eyes liberally in cold water. Seek medical attention immediately.
1. Press the cover release and open the printer’s top cover fully.
If the printer has been powered on, the fuser will be hot. This area
is clearly labelled. Do not touch.
To Next Page
Loading...
