45
800.788.5572 DuraLabel.com
Menu functions
ITEM SETTINGS EXPLANATION
LF FUNCTION LF / LF+CR Selects whether a received line feed character (0Ah) also
causes a carriage return.
CR FUNCTION CR / CR+LF Selects whether a received carriage return character (0Dh)
also causes a line feed.
WHITE PAGE
SKIP
OFF / ON Selects whether blank pages are printed or not.
A4 PRINT WIDTH 78 COLUMN
80 COLUMN
Sets the number of columns subject to Auto LF with A4
paper in PCL. This is the value when Auto CR/LF Mode is
set to OFF with the 10CPI character.
SYMBOL SET PC-8
(Default Symbol Set only
shown)
PCL symbol set. If the font source and number are
changed to one which does not support the selected
symbol set, this must be changed to an available symbol
set for that font.
FONT PITCH 0.44CPI~
10.00CPI~
99.99CPI
Sets the width of the PCL default font in characters/inch
(CPI).
Default font is the fixed-pitch, scalable font. The value is
displayed to the second decimal place
Displayed only when the font selected in Font No. is fixed-
spacing, scalable font.
FONT NO. I0 ~ I90 Sets the current default font number from the currently
selected source.
SYS CONFIG MENU
This menu adjusts general printer settings to suit the way you prefer to work.
ITEM SETTINGS EXPLANATION
POW SAVE TIME 1 MIN
2 MIN
3 MIN
4 MIN
5 MIN
10 MIN
15 MIN
30 MIN
60 MIN
120 MIN
Adjusts the idling time before the printer automatically
switches into power save mode. In this mode power
consumption is reduced to a low level required to just keep
the printer operating and ready to receive data. When a job
is sent the printer will require a warm-up time of up to 1
minute before printing can begin.
ERROR REPORT ON
OFF
If ON, the printer will print error details when a PostScript
Emulation error occurs.
JAM RECOVERY ON
OFF
Specifies whether the printer should perform jam recovery
after a paper jam has occurred. If ON, the printer will
attempt to re-print any pages lost due to a paper jam once
the jam has been cleared.
LOW TONER CONTINUE
STOP
Specifies whether the printer should continue printing even
after a low toner condition is detected.
WAIT TIMEOUT 5~40 SEC~300,
OFF
Specifies how many seconds the printer will wait when
received data pauses before forcing a page eject. In
PostScript Emulation mode the job will be cancelled if
timeout occurs.
PCL EMULATION MENU (continued)
To Next Page
Loading...
