DuraLabel Catalyst - Memory Menu; Sys Adjust Menu

53
800.788.5572 DuraLabel.com
Menu functions
MEMORY MENU
Not displayed as default. This menu is displayed only when set to ENABLE in OP
MENU of Administrator menu.
This menu sets the conditions of memory allocated to the buffer and resource.
ITEM SETTINGS EXPLANATION
RECEIVE BUF SIZE AUTO
0.5MB
1MB
2MB
4MB
8MB
16MB
32MB
Sets the size of the receive buffer.
RESOURCE SAVE AUTO
OFF
0.5MB
1MB
2MB
4MB
8MB
16MB
32MB
Sets the size of the resource saving area
SYS ADJUST MENU
Not displayed as default. This menu is displayed only when set to ENABLE in OP
MENU of Administrator menu.
ITEM SETTINGS EXPLANATION
X ADJUST +2.00MILLIMETER
~
0.00MILLIMETER
~
-2.00MILLIMETER
Adjusts the position of a whole print image in the direction
perpendicular to the direction the paper runs, that is
horizontally, in 0.25 mm increments. Any parts of the print
image that are outside the printable area as a result of
this shift will be cropped.
Y ADJUST +2.00MILLIMETER
~
0.00MILLIMETER
~
-2.00MILLIMETER
Adjusts the position of a whole print image in the direction
the paper runs, that is vertically, in 0.25 mm increments.
Any parts of the print image that are outside the printable
area as a result of this shift will be cropped.
DUPLEX X ADJUST +2.00MILLIMETER
~
0.00MILLIMETER
~
-2.00MILLIMETER
When printing the reverse page of a duplex job, adjusts
the position of the whole print image in the direction that
is perpendicular to the direction the paper runs, that is
horizontally, in 0.25 mm increments. Any parts of the print
image that are outside the printable area as a result of
this shift will be cropped.
DUPLEX Y ADJUST +2.00MILLIMETER
~
0.00MILLIMETER
~
-2.00MILLIMETER
When printing the reverse page of a duplex job, adjusts
the position of the whole print image in the direction the
paper runs, that is vertically, in 0.25 mm increments. Any
parts of the print image that are outside the printable
area as a result of this shift will be cropped.