DuraLabel Catalyst - Page 55

55
800.788.5572 DuraLabel.com
Menu functions
ITEM SETTINGS EXPLANATION
OP MENU
(cont.)
USB MENU ENABLE
DISABLE
Set up ENABLE/DISABLE condition for USB MENU category.
If DISABLE is selected, USB MENU category of
USERS MENU will not appear.
NETWORK MENU ENABLE
DISABLE
Set up ENABLE/DISABLE condition for NETWORK
MENU category.
If DISABLE is selected, NETWORK MENU category of
USERS MENU will not appear.
MEMORY MENU ENABLE
DISABLE
Set up ENABLE/DISABLE condition for MEMORY ME
NU category.
If DISABLE is selected, MEMORY MENU category of
USERS MENU will not appear.
SYS ADJUST
MENU
ENABLE
DISABLE
Set up ENABLE/DISABLE condition for SYS.ADJUST
MENU category.
If DISABLE is selected, SYS.ADJUST MENU category
of USERS MENU will not appear.
MAINTENANCE
MENU
ENABLE
DISABLE
Set up ENABLE/DISABLE condition for
MAINTENANCE MENU category.
If DISABLE is selected, MAINTENANCE MENU
category of USERS MENU will not appear.
USAGE MENU ENABLE
DISABLE
Set up ENABLE/DISABLE condition for USAGE
MENU category.
If DISABLE is selected, USAGE MENU
category of USERS MENU will not appear.
NEARLIFE STATUS ENABLE
DISABLE
Set LCD panel control at the time of near-life
warning for drum, fuser and belt.
Enable: Display a near-life warning.
Disable: Do not display a near-life warning.
LIFE WARNING ENABLE
DISABLE
If DISABLE is selected, the printer does not display
life warning after cover opening and closing
Display Condition: NEARLIFE STATUS is set to
DISABLE.
CONFIG.
MENU
NEARLIFE LED ENABLE
DISABLE
Enables/disables illumination of front panel LED
when “near-end-of-life” warning of a toner, drum,
fuser, or belt occurs. Attention LED is lit when
setting is enabled, inhibited when disabled.
ECO MODE ON
OFF
When ON, if the machine is in power save mode
and you send a small print job (1 or 2 pages), the
machine will print the job without warming the fuser
to the “normal” operating temperature beforehand.
When you change the setting and exit the Admin
Menu, the machine will power cycle then the
following message is displayed “PLEASE POWER
OFF/ON”. Switch the power off then turn the
machine back on.
ADMINISTRATOR MENU (continued)