DURKOPP ADLER 745-35-10 A - Automatic Tape Feeder Settings (745-35-10 A Only)

Programming
118 Operating Instructions 745-35-10 S/745-35-10 A - 03.0 - 04/2017
To set the corner knife parameters:
1. Press the desired button.
2. Enter the desired value using the numeric keypad.
3. Confirm with OK.
Set corner knife correction seam begin./seam end
Fig. 100: Set corner knife correction seam begin./seam end
Seam end outer right On/Off
Correction seam end left
• -9.9 mm - 9.9 mm
Correction seam end right
• -9.9 mm - 9.9 mm
Symbols Meaning