Setup
Operating Instructions 745-35-10 S/745-35-10 A - 03.0 - 04/2017 227
7.7 Commissioning
You should perform a sewing test when finished setting up the sewing unit.
To perform a sewing test:
1. Insert the power plug.
2. Thread needle thread ( p. 21).
3. Insert a new hook bobbin ( p. 35).
4. Switch on the main switch.
The control is initialized.
5. Press the pedal back.
The reference run starts. The transport carriage moves to its rear end
position.
The reference run is necessary in order to obtain a defined starting
position of the transport carriage.
6. Select the seam program ( p. 97).
7. Insert sewing material ( p. 54).
8. Press the pedal.
The different steps of the positioning procedure are triggered one
after another. The sewing procedure is started.
WARNING
Risk of injury from sharp parts and laser light!
Puncture or blindness.
Turn off the main switch before threading needle
thread and bobbin thread.
Do NOT look directly into the light source of the
laser beam.
NOTICE
Property damage may occur!
Moving the transport carriage without sewing material damages the
transport clamp coating.
Before starting to sew, make sure there is sewing material under the
transport clamps.
To Next Page
Loading...
