DURKOPP ADLER 745-35-10 A User Manual

Table of Contents
Operating Instructions 745-35-10 S/745-35-10 A - 03.0 - 04/2017 1
1 About these instructions ........................................................... 3
1.1 For whom are these instructions intended?.................................. 3
1.2 Representation conventions – symbols and characters............... 3
1.3 Other documents.......................................................................... 5
1.4 Liability.......................................................................................... 5
2 Safety........................................................................................... 7
2.1 Basic safety instructions............................................................... 7
2.2 Signal words and symbols used in warnings................................ 8
3 Machine description................................................................. 11
3.1 Components of the machine 745-35-10 S.................................. 11
3.2 Components of the machine 745-35-10 A.................................. 13
3.3 Proper use.................................................................................. 14
3.4 Declaration of Conformity........................................................... 15
4 Operation................................................................................... 17
4.1 Preparing the machine for operation .......................................... 17
4.2 Switching on the machine........................................................... 17
4.3 Swiveling the folding station to the side...................................... 18
4.4 Locking the folding station in place............................................. 18
4.5 Changing needles....................................................................... 20
4.6 Threading the needle thread ...................................................... 21
4.7 Winding the bobbin thread.......................................................... 24
4.8 Replacing the bobbin thread reels.............................................. 25
4.9 Thread tension............................................................................ 26
4.9.1 Setting the needle thread tension............................................... 27
4.9.2 Setting the bobbin thread tension............................................... 28
4.10 Sliding back the hood and removing the fabric sliding plate....... 29
4.11 Swiveling up the machine head.................................................. 31
4.12 Swiveling down the machine head ............................................. 32
4.13 Remaining thread monitor .......................................................... 33
4.14 Stacker control............................................................................ 35
4.15 Corner knife station .................................................................... 36
4.15.1 Swiveling corner knife station in/out 745-35-10 S....................... 36
4.15.2 Swiveling corner knife station in/out 745-35-10 A....................... 37
4.15.3 Adjusting corner knife................................................................. 38
4.16 Setting the reference position..................................................... 39
4.17 Performing a quick stop.............................................................. 40
4.18 Flap and piping projection ..........................................................40
4.18.1 Folder monitor (745-35-10 A only).............................................. 42
4.19 Additional equipment.................................................................. 43
4.19.1 Downholder and pocket bag clamp ............................................ 43
4.19.2 Waistband clamp (745-35-10 A only) ......................................... 44
4.19.3 Roll-off device (745-35-10 A only).............................................. 45
4.19.4 Blow-out device .......................................................................... 46
4.19.5 Bundle clamp..............................................................................47
4.19.6 Tape feeder with automatic cutter (745-35-10 A only)................ 48
4.19.7 Vacuum device (745-35-10 A).................................................... 51
4.20 Sewing........................................................................................ 52
4.20.1 Start sewing................................................................................ 52
4.20.2 Working method A (production of trousers)................................ 54

DURKOPP ADLER 745-35-10 A Specifications

General

Brand	DURKOPP ADLER
Model	745-35-10 A
Category	Sewing Machine
Language	English