DURKOPP ADLER 745-35-10 A - Threading the Needle Thread

Operation
Operating Instructions 745-35-10 S/745-35-10 A - 03.0 - 04/2017 21
Important
The groove of the left needle (4), as viewed from the operator side of the
sewing unit, must point to the left, while the groove of the right needle (5)
must point to the right (see diagram).
4. Tighten screws (3).
Information
By default, the 745-35-10 is equipped with needles that have a thickness
of Nm 100.
4.6 Threading the needle thread
Fig. 9: Threading the needle thread (1)
Left needle thread
To thread the left needle thread:
5. Swivel the folding station to the side ( p. 18).
6. Fit the thread reel on the thread reel holder (1).
7. Feed the thread from the thread reel through the hole (2) of the thread
reel holder.
CAUTION
Risk of injury from sharp parts!
Puncture.
Only thread the thread with the sewing unit
switched off.
(1) - Thread reel holder (2) - Holes
②①