Operation
48 Operating Instructions 745-35-10 S/745-35-10 A - 03.0 - 04/2017
2. Insert the hind trousers parts into the bundle clamp (3).
3. Release the pedal.
The bundle clamp (3) closes.
4. Deposit the clamped hind trousers parts on the table extension (4).
5. With the lifting of the transport clamps after the sewing and cutting
sequence, the transport rollers (1) lower.
6. The transport rollers (1) convey the hind trousers part out of the sewing
unit.
The hind trousers part will then dangle from the bundle clamp (3).
4.19.6 Tape feeder with automatic cutter (745-35-10 A only)
The electromotive, length-controlled tape feeder with automatic cutter
transports the reinforcement strip under the pocket opening and cuts it off
at the seam end.
The process is carried out during the cycle time. No further positioning and
working times are required.
Inserting the reinforcement strip
Fig. 38: Inserting the reinforcement strip (1)
To insert the reinforcement strip:
1. Loosen the screw (1) and pull off the adjusting ring (2) from the shaft.
2. Remove the empty tape roll including the adapter (3).
3. Insert the adapter (3) into a new tape roll on the left and the right.
4. Slip the adjusting ring (2) back onto the shaft.
5. Tighten the screw (1) again.
(1) - Screw
(2) - Adjusting ring
(3) - Adapter
(4) - Wire bow
To Next Page
Loading...
