Operation
Operating Instructions 745-35-10 S/745-35-10 A - 03.0 - 04/2017 29
4.10 Sliding back the hood and removing the fabric sliding plate
To provide for easier access to the transport clamps, the hood can be
moved out of the way (745-35-10 A only).
Fig. 18: Sliding back the hood and removing the fabric sliding plate (1)
To slide back the hood (shown by the example of the 745-35-10 A):
1. Switch off the main switch.
2. Loosen the screw (2) on the hood (1).
3. Slide the hood (1) to the left. You can now access the transport clamps.
4. Slide the hood (1) back to the right until it locks audibly into place.
CAUTION
Risk of injury from moving parts!
Crushing.
Switch off the main switch. Do not slide the hood
back and remove the fabric sliding plate back
UNLESS the sewing unit is switched off.
(1) - Hood (2) - Screw
To Next Page
Loading...
