DURKOPP ADLER 745-35-10 A - Cleaning

Maintenance
202 Operating Instructions 745-35-10 S/745-35-10 A - 03.0 - 04/2017
Maintenance interval
6.1 Cleaning
Work to be carried out Operating hours
8 40 160 500
Removing lint and thread remnants

Clean the lenses of the light barriers

Clean the piping cutter (745-35-10 A only)

Checking the water level

Top off the oil reservoir

Check the pneumatic system

WARNING
Risk of injury from flying particles!
Flying particles can enter the eyes, causing injury.
Wear safety goggles.
Hold the compressed air gun so that the particles
do not fly close to people.
Make sure no particles fly into the oil sump.
NOTICE
Property damage from soiling!
Lint and thread remnants can impair the operation of the machine.
Clean the machine as described.
NOTICE
Property damage from solvent-based cleaners!
Solvent-based cleaners will damage paintwork.
Use only solvent-free substances for cleaning.