Operation
22 Operating Instructions 745-35-10 S/745-35-10 A - 03.0 - 04/2017
Fig. 10: Threading the needle thread (2)
8. Insert the thread in a wavelike manner through the left holes (11) in
the mounting plate, as shown above.
9. Insert the thread through the guide (10).
10. Feed the thread counterclockwise through the tensioner (9).
11. Feed the thread clockwise through the tensioner (8).
12. Insert the thread through the thread tensioning spring (7).
13. Insert the thread through the hole (6) in the mounting plate.
14. Insert the thread through the upper hole in the thread lever (1).
15. Insert the thread through the thread advancing device (2).
16. Insert the thread through the guide (3).
17. Feed the thread through the needle thread monitor (4).
18. Insert the thread through the guide (5).
19. Feed the thread into the left needle.
Right needle thread
To thread the right needle thread:
1. Swivel the folding station to the side ( p. 18).
2. Fit the thread reel on the thread reel holder.
3. Feed the thread from the thread reel through the hole (2) of the thread
reel holder.
4. Insert the thread through the guide (1).
(1) - Thread lever
(2) - Thread advancing device
(3) - Guide
(4) - Needle thread monitor
(5) - Guide
(6) - Hole
(7) - Thread tensioning spring
(8) - Voltage
(9) - Voltage
(10) - Guide
(11) - Holes
To Next Page
Loading...
