Operation
Operating Instructions 745-35-10 S/745-35-10 A - 03.0 - 04/2017 23
Fig. 11: Threading the needle thread (3)
5. Insert the thread in a wavelike manner through the right holes (11) in
the mounting plate, as shown above.
6. Feed the thread counterclockwise around the tensioner (18).
7. Feed the thread through the guides (16) and (17).
8. Feed the thread counterclockwise around the tensioner (15).
9. Insert the thread through the thread tensioning spring (14).
10. Insert the thread through the hole (13).
11. Insert the thread through the lower hole in the thread lever (1).
12. Insert the thread through the thread advancing device (2).
13. Insert the thread through the guide (3).
14. Feed the thread through the needle thread monitor (12).
15. Insert the thread through the guide (5).
Feed the thread into the right needle.
(1) - Thread lever
(2) - Thread advancing device
(3) - Guide
(5) - Guide
(11) - Hole
(12) - Needle thread monitor
(13) - Hole
(14) - Thread tensioning spring
(15) - Tensioner
(16) - Guide
(17) - Guide
(18) - Tensioner
To Next Page
Loading...
