Programming
144 Operating Instructions 745-35-10 S/745-35-10 A - 03.0 - 04/2017
Toolbox configuration
The display switches to Toolbox configuration.
Fig. 119: Toolbox configuration (1)
The toolbox can be loaded with 12 tools.
These 12 tools are linked in a quick-access menu on the start screen.
Empty boxes indicate that no tool has been selected for this position yet.
Depending on the class and method, the display will only show the tools
available for that class and method.
To configure the toolbox:
1. Press on a blank field to assign an available position.
OR
1. Press on a position that has already been assigned in order to change
the setting.
The display switches to an overview of the possible tools. Tools that
have already been selected are highlighted in gray.
The display will only show the tools available for the selected class.
To Next Page
Loading...
