Programming
Operating Instructions 745-35-10 S/745-35-10 A - 03.0 - 04/2017 151
To test the machine:
1. Press the desired button.
The user interface for setting the desired item is displayed.
USB_Logging
USB_Logging is used to perform on error analysis of the OP7000.
To carry out USB Logging:
1. Create a Log.txt file.
2. Load the Log.txt file onto a USB key.
3. Plug the USB key with the Log.txt file into the USB port.
4. Confirm with OK.
USB_Logging automatically writes all status messages of the
OPO7000 to the Log.txt file until the machine is switched off.
Test tape feeder (745-35-10 A only)
• Tape throwing
• Tape trimming
Machine workflow test p. 159
Test step motor p. 163
Adjust and test control panel p. 165
Symbol Description
To Next Page
Loading...
