DURKOPP ADLER 745-35-10 A - Reading Data from USB Key

Programming
Operating Instructions 745-35-10 S/745-35-10 A - 03.0 - 04/2017 185
Writing data from the system to the USB key
 The display switches to Data transfer to USB.
Fig. 155: Data transfer to USB (1)
To write data from the system to the USB key:
1. Select which data you wish to store on the USB key:
• Current seam program
• All seam programs and sequences
• Global parameters
• Machine config.
• All data
 The selected option is highlighted in orange.
2. Press the button to confirm.
 The software checks the USB key.
The selected option is written to the USB key.
Depending on the amount of data selected, the process may
take anywhere from a few seconds to approx. 2 minutes.