Operation
Operating Instructions 745-35-10 S/745-35-10 A - 03.0 - 04/2017 41
Setting the sewing depth of the flap (manual feed only)
Fig. 31: Setting the sewing depth of the flap
To set the sewing depth of the flap:
1. Loosen the screws (8).
2. Shift the position of the stop (7) in the slotted hole.
3. Tighten the screws (8).
Piping strip length
The length of the piping strip must be dimensioned in such a way that
it projects approx. 20 mm beyond seam beginning and seam end.
The length of the piping strip is calculated as follows:
Piping strip length = sewing length + 2 x 20 mm
(7) - Stop (8) - Screws
To Next Page
Loading...
