Operation
Operating Instructions 745-35-10 S/745-35-10 A - 03.0 - 04/2017 59
Positioning the piping strip
Double pipe
Fig. 50: Double pipe
To position the double pipe:
Position the piping strip centered on the transport clamps and flush with
the front edges.
Single pipe left with separately positioned facing right
Fig. 51: Single pipe left with separately positioned facing right
To position a single pipe with separately positioned facing on the right:
1. Position the piping strip on the left transport clamp flush with the cutting
line.
2. Position the facing on the right transport clamp. This positioning method
requires the Flap clamp right, which is available as additional equipment.
The edges (9) and (10) must be sufficiently seized by the needle, but
must not be cut by the middle knife.
(9) - Edge (10) - Edge
To Next Page
Loading...
