!
3 M e m o r y M o d u l e
4 Replacement Procedures
4-11 Satellite Pro L50-G / dynabookP*-C* MaintenanceManual
Installing Memory Module
Install Memory Module accordingto the following proceduresandFigure 4-2 after
checking that the computer is turned off in boot mode.
CAUTION: Install the optionalmemoryafter turning off the computer.If this is
violated, the computer or memorycan be damaged.
1. Insert Memory Module into the connector at anangle of 45 degrees.
2. Pressdown Memory Module so that it is securedwith both memory lock latches.
3. After the computer is turned on, checkthe hardwareconfiguration in the Hardware
Setup or TSETUP program to makesurethat the installed Memory Module hasbeen
recognized by the system. If it hasnot beenrecognized yet, check the connections.
4. If the unit only containsonepcsof Memory Module, insert it into the connector
which is nearspeaker.
To Next Page
Loading...