dynabook Satellite Pro L50-G - Touchpad; Procedure 1 Windows Applica�On Test; Procedure 2 Connector Check and Replacement Check; Procedure1 Windows Application Test

2.11 Touchpad 2 Troubleshooting
SatellitePro L50-G / dynabookP*-C* MaintenanceManual 2-19
2.11 Touchpad
               
             
      
Procedure1 Windows Application Test
Procedure 2 Connector Check and Replacement Check
Procedure 1 Windows Application Test
              
           
               
                
 
Procedure 2 Connector Check and Replacement Check
             
             
            
          
Check1 Make sure Touchpador SecurePadModule hasbeen firmly connected to the
connector on SystemBoard. Alsomake sure the tape is not stuckto any part
of TouchpadModule and Touchpador SecurePadModule is free of foreign
matters.
            
               
              
              
     
Check2 Touchpador SecurePadModule may be faulty. Replaceit with a new one
following the stepsdescribed in Chapter 4. If Touchpador SecurePad
Module replaced isstill not functioning properly, perform Check3.
Check3 SystemBoard may be defective. Replace SystemBoard with new one
following stepsdescribedin Chapter 4.
Touchpad /
Secure Pad
Module
System Board