4.11 DC IN harness 4 Replacement Procedures
4-27 Satellite Pro L50-G / dynabookP*-C* MaintenanceManual
4.11 DC-IN harness
RemovingDC-IN Harness
RemoveDC-IN Harnessaccording to the following proceduresandFigure 4-12.
1. Removetapefor fasten DC-IN cable.
2. Disconnect DC-IN harnesscable from CN6000 on systemboard.
3. Lift from DC-IN connector, then removeDC-IN harness.
Figure 4-12 RemovingDC-IN Harness
Installing DC-IN Harness
Install DC-IN Harnessaccording to the following proceduresandFigure 4-12.
1. PlaceDC-IN harnessin correct position on systemboard.
2. Connect DC-IN harnesscable to CN6000 on systemboard.
3. Stick tapeto fasten DC-IN cable.
To Next Page
Loading...