dynabook Satellite Pro L50-G - Camera; Procedure 1 Windows Application Test; Procedure 2 Connector Check and Replacement Check; Procedure1 Windows Application Test

2 Troubleshooting 2.18 Camera
2-26 SatellitePro L50-G / dynabookP*-C* MaintenanceManual
2.18 Camera
               
           
            
   
Procedure1 Windows Application Test
Procedure 2 Connector Check and Replacement Check
Procedure 1 Windows Application Test
             
               
        
Procedure 2 Connector Check and Replacement Check
            
              
           
        
Check1 Make sure CameraModule FPCCablehasbeen firmly connected to the
connector on SystemBoard. Alsomake sure Camera Module is free of
foreign matters.
            
             
            
 
Check2 CameraModule maybe faulty. Replaceit with a new one following the steps
describedin Chapter 4. If CameraModule replacedisstill not functioning
properly, perform Check3.
Check3 SystemBoard may be defective. Replace SystemBoard with a new one
following the stepsdescribedin Chapter 4.
Camera
Module
System Board