dynabook Satellite Pro L50-G - Memory; Procedure 1 Test Program Check; Procedure 2 Connector Check and Replacement Check; Procedure1 Test Program Check

2.8 Memory 2 Troubleshooting
SatellitePro L50-G / dynabookP*-C* MaintenanceManual 2-15
2.8 Memory
            
    
Procedure 1 Test Program Check
Procedure 2 Connector Check and Replacement Check
Procedure 1 Test Program Check
             
           
               
                    
      
Procedure 2 Connector Check and Replacement Check
             
             
             
   
Check1 Make sureMemory Module hasbeen firmly connectedto the connectoron
SystemBoard. Alsomake surethe tape isnot stuckto anypart of Memory
Module and Memory Module isfree of foreignmatters.
            
                 
             
             
Check2 Memory Module maybe faulty. Replaceit with a new one following the
stepsdescribedin Chapter 4. If Memory Module replaced isstill not
functioning properly, perform Check3.
Check3 SystemBoard may be defective. Replace SystemBoard with new one
following stepsdescribedin Chapter 4.
Memory Module
System Board