dynabook Satellite Pro L50-G - Page 140

4 Replacement Procedures 4.133 SystemBoard
Satellite Pro L50-G / dynabookP*-C* MaintenanceManual 4-32
Install SystemBoard according to the following proceduresand Figures 4-15.
1. Connect IO board cable to CN200 on another side of SystemBoard.
2. PlaceSystemBoard in correct position.
3. SecuringSystemBoard with four M2.0x2.5 black Phillips headscrew.
( ▲ mark portions)
4. Connect IO board cable to CN9502 on IO Board, then attach the cable.
5. Connect following cable to the connector on SystemBoard:
- Speakercable to CN600.
- LED board cable to CN102.
- SecurePadcable to CN281.
- Touch Padcable to CN280.
- Keyboard cable to CN205.
NOTE:
Be sure to place all cablesinto the ditch to avoid the damageduring assemblingthe
bottomcover.
NOTE:
Be sure to align Type-C connector to Top Cover, when place systemboard on the
unit..